The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118300 is the right harness to wire trailer lights to your 2005 Chrysler Town and Country. This custom wiring harness adds a 4-way trailer connector to your vehicle. The T-One connector plugs directly into existing wiring so no cutting, splicing or tapping are required.
It is recommended to apply a small amount of Dielectric Grease to prevent corrosion. I would recommend using Dielectric Grease for Electrical Connectors... view full answer...
There is one ball mount that meets your criteria for 10 inches of rise as well as more than 7 inches of clearance from the hitch pin hole to the hitch ball:
- Draw-Tite Ball Mount # 80248
This ball mount will give you 9-3/4 inches of rise (that 1/4 inch is not a factor; you just need to be within an inch or so of level) and measures from 9 inches from the center of the hitch pin hole to the center of the hitch ball.
For a hitch ball, depending on your trailer's coupler you will need... view full answer...
You will need to know what class hitch you currently have on your Town and Country. This should be indicated on the safety warning label on the hitch.
If you have a class l hitch installed, there will be a stop or indent inside the receiver wall that prevents Class ll carriers or ball mounts from being used. If you find that you have a class l receiver, it is rated for a tongue weight capacity of 200 lbs, and you would need a class l rack or carrier. All Class l bike carriers are limited... view full answer...
We do not carry the Stowaway cargo carriers, so all I was able to go by was photos I managed to find online. From what I could see, it does not look like the carrier swings completely clear of the vehicle on the right side, which would interfere with the tent. Take a look at the diagram and photo I edited for you, which should give you an idea of how things would fit.
As you can see in the diagrams, I do not believe that the cargo carrier you mentioned will swing far enough away from the... view full answer...
The best towing mirrors for your 2013 Chrysler Town and Country will be custom fit mirrors, and there is one option that fits your T and C:
- K-Source Snap & Zap Custom Towing Mirrors # KS80720
The reason you want the custom mirrors designed specifically for your vehicle is because they provide the tightest fit, which means the vibration that can occur with universal mirrors won't occur, giving you the best view of what is behind you at all times for the safest towing experience.
I have... view full answer...
I recommend replacing your lead leg with one that has the same dimensions as your new follow leg, the Replacement Lead Jack w/ Drop Leg # LG-179013.
This leg is 29-1/2" long, 2-1/2" wide, has a 4,000 lb weight capacity and can be used with most landing gear sets, including Atwood, Venture, and Lippert. I've included a link to a video review for you to take a look at. view full answer...
The Highland Semi-Custom Cargo Area Mat you referenced, part # 4401200 measures 54-1/2 inches x 49-1/4 inches and is intended to be trimmed to fit. The mat features molded lines on the back that will help you trim it to fit.
As long as the floor in the cargo area of your Town and Country measures less than 54-1/2 by 49-1/4, the mat will work just fine for you.
If you would prefer a custom-fit mat, you can see our selection of those by clicking the provided link. view full answer...
I did some research on the 2012 Chrysler Town and Country and found that the lip is part of the hatch structure on the vehicle and as such you will be able to use a trunk mount bike rack. The Thule Passage # TH910XT will fit your T and C. I have included links to the instructions and a review video of the rack for you.
If you will be carrying womens, childrens, or alternative frame bikes, you will need to use an adapter bar, # TH982XT, for greater ground clearance and to carry the bikes... view full answer...
The Hollywood Racks Destination Bike Rack for 4 Bikes # HR4000 can only hold up to 35 lb bikes. This rating isn't necessarily a "whole bike rack" rating as much as it is for the cradles and straps that hold each individual bike.
If you're only needing to carry 2 bikes at a time then I recommend checking out the Swagman E-Spec # S94FR or the Yakima OnRamp # Y36FR. The E-Spec is more cost-effective while the OnRamp uses the same type of clamping-style that the Hollywood destination uses... view full answer...
The Yakima HullRaiser to HullRaiser Aero Conversion Kit # Y8860031 will allow your HullRaiser roof-mounted kayak carrier to mount to the factory roof rack crossbars on your 2014 Chrysler Town and Country van. Two kits will be needed for a complete conversion.
If you also need replacement plugs to secure your carrier pads onto the J-cradle bases you can use kit # Y8890058. view full answer...
The best way to determine the correct rise you will be need will be to first install the Curt hitch. Then park your Town and Country van and the trailer on level ground. Measure from the ground to the top of the receiver opening on the trailer hitch. Then, with the trailer level, measure from the ground to the bottom of the coupler.
If the coupler is higher, the difference is the amount of rise you will need. You can then go through our ball mount main page, linked for you, to find the... view full answer...
If you are looking for a box that will not interfere with the rear hatch on your 2010 Chrysler Town and Country then from Thule the best option is the Motion, # TH629706. The Force XL boxes have not been confirmed to fit without interfering with the rear hatch. view full answer...
I checked with Thule and the Thule OutWay 2 Bike Carrier # TH45JV is confirmed to fit your 2009 Chrysler Town and Country minivan. I attached installation instructions and a review video for this product for you to check out.
As far as if it is legal for the bike to extend beyond the sides of your vehicle, you will need to consult your local laws and regulations on the issue to know for certain.
If you plan on carrying any women's or alternative framed bikes without a horizontal top tube... view full answer...
The Malone SeaWing Kayak Carrier and Load Assist w/ Tie-Downs # MPG113MD will fit great on the OEM crossbars for your 2008 Chrysler Town and Country. You may need to offset them some to be able to fit 2 kayaks laying flat. I recommend taking some measurements and seeing if your kayaks will fit side-to-side.
If they don't then I recommend using the Malone DownLoader Kayak Carrier and TelosXL Load Assist w/ Tie-Downs # MPG114MD-351XL instead. This only comes with 1 set of cradles though... view full answer...
You'll need one of the following etrailer trailer hitches for your 2007 Chrysler Town and Country depending on if you have the Stow-N-Go seats or not:
With Stow-N-Go Seats - # e39KR
Without Stow-N-Go Seats - # e43KR
The Stow-N-Go seats take up extra space underneath your van which is why there are different fits.
If you are installing a hitch to use a bike rack then I recommend checking out the Thule Apex Swing XT Bike Rack # TH9027XT which is perfect for families as it gives you space... view full answer...
I checked with Thule and they have confirmed that the Thule OutWay Platform-Style 2 Bike Carrier # TH65JV will fit your 2008 Chrysler Town and Country. view full answer...
There is a trailer hitch receiver fit for your 2005 Chrysler Town and Country with Stow-N-Go seats:
- etrailer Trailer Hitch Receiver # e39KR
I verified for you that this is the correct fit for the Stow-N-Go seating on your Town and Country, and does not require any drilling or other modification to install.
The only other thing you may need, if you plan on doing some towing, is a trailer wiring harness. The correct fit for your '05 Town and Country is the T-One Vehicle Wiring Harness... view full answer...
I spoke with my contact at Timbren about the compatibility of the two systems, and he said that as long as the Timbren Rear Suspension Enhancement System # TDVRRT and the shock absorbers don't occupy the same space they will work great together.
The Timbren system will replace the bump stop inside the coil spring on your 2010 Chrysler Town and Country. I have attached an installation video of the # TDVRRT system on a 2009 Dodge Grand Caravan for you to see the installation process. The... view full answer...
Go To Results